This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Accurate torque values and clearances prevent mechanical failure and premature wear. Always use a calibrated torque wrench during reassembly. General Specifications 4-Cylinder, In-line, OHC (Overhead Camshaft) Displacement: 1,270 cc (1.3 Liters) Bore x Stroke: 76.0 mm × 70.0 mm Compression Ratio: 9.0:1 (Standard) Valves per Cylinder: 2 (8 valves total) Critical Torque Values
Loosen the tensioner bolt to let it spring back against the belt. Rotate the crankshaft two full turns clockwise to seat the belt properly. Re-verify that all timing marks perfectly align, then torque the tensioner bolt to 16–22 Nm (12–16 ft-lbs). 6. Troubleshooting Common E13 Problems nissan e13 engine service manual
The E13 relies on a clean timing belt setup to tie the crankshaft and camshaft synchronization together. Unlike later timing-chain configurations found in GA or HR series engines, regular belt renewal prevents catastrophic mechanical damage.
Using a calibrated torque wrench is mandatory to prevent stripped threads, warped cylinder heads, or blown gaskets. Always apply torque in the factory-recommended sequence (working from the center outward). Torque Specification (Metric) Torque Specification (Imperial) 68 – 74 Nm 50 – 55 ft-lbs Main Bearing Caps 49 – 54 Nm 36 – 40 ft-lbs Connecting Rod Nuts 31 – 36 Nm 23 – 26 ft-lbs Flywheel Bolts 78 – 88 Nm 58 – 65 ft-lbs Spark Plugs 15 – 20 Nm 11 – 15 ft-lbs Crankshaft Pulley Bolt 118 – 127 Nm 87 – 94 ft-lbs 3. Routine Maintenance & Tune-Up Procedures Valve Clearance Adjustment This public link is valid for 7 days
Based on real-world mechanic forums and Nissan TSBs (Technical Service Bulletins), here are the top failures for the E13 engine—and exactly where the service manual provides the fix.
Torque the tensioner pulley lock bolt to 31–40 Nm (23–30 ft-lbs). Reassemble the timing covers, pulleys, and drive belts. 5. Fuel System & Carburetor Tuning Can’t copy the link right now
Reinstall the valve cover with a new gasket to prevent oil leaks. 4. Timing Belt Replacement Procedure