Click the icon on the toolbar, or navigate to Device -> Read . Wait for the progress bar to complete.
Check your COM port settings in the software. Ensure the cable is seated firmly.
Never attempt to read or write to your GM360 using a weak power source. Connect the radio to a stable 13.8V DC bench power supply. A sudden drop in voltage during data transmission can corrupt the radio's EEPROM, resulting in a bricked device ("Codeplug Error"). Installation and Initial Configuration Step 1: Install Drivers motorola gm360 programming software
Always start by clicking "Read Device." This creates a backup of the current codeplug. Save this file immediately—if something goes wrong, you’ll need it to restore the radio. 3. Key Configurations
Some used radios are password-protected. You may need to perform a factory reset or use a global codeplug to bypass this. Click the icon on the toolbar, or navigate to Device -> Read
Click the icon on the toolbar (or go to Device -> Read ). Wait for the progress bar to complete.
: The technician modifies the data within the CPS interface. Writing to Radio Ensure the cable is seated firmly
Set up Select 5 (5-Tone), DTMF, and MDC1200 signaling protocols.
: Stop and save this original file. Click File -> Save As and name it GM360_Original_Backup.cp . This allows you to restore the radio if you make a mistake. 4. Modifying Channels and Frequencies
: Immediately click File -> Save As and save this original file as a backup (e.g., GM360_Original_Backup.cpg ). Step 4: Editing Frequencies and Channels
The official software used to program the GM360 is .