Keyence Gs-11pc Manual Link

The GS-11PC uses an 8-pin M12 connector.Correct wiring is essential to prevent damage to the PNP semiconductor outputs. Pinout Assignment +24 VDC Power Supply.

Safety inputs allow for Emergency Stop switches to be connected directly in series. 3.1 Troubleshooting Wiring

The safety guard is closed, and the OSSD outputs are active (safe state). keyence gs-11pc manual

: Supports up to 30 units in a standard chain, or up to 4 units when using Y-shaped connectors. Environmental Resistance , allowing it to withstand high-pressure washdowns. Safety Rating (IEC 61508) and PLe, Category 4 (EN ISO13849-1) standards. Keyence India Installation & Troubleshooting Guide

Actuator is present but misaligned or close to the detection limit. Solid Red: Guard open, OSSDs are inactive. Flashing Red: Internal fault or wiring error detected. 4. Actuator Pairing (Teaching Code) The GS-11PC uses an 8-pin M12 connector

: You can connect up to 20 units in a series to save on wiring and safety controller inputs. Locking Function : As a power-to-release model, the

Features highly visible LED indicators on the switch body for rapid status diagnostics. Safety Rating (IEC 61508) and PLe, Category 4

Ensure that when the gate is fully closed, the gap between the switch and actuator is between 2 mm and 8 mm. 5. LED Status Indicator Codes

Ensure the alignment arrows engraved on both the sensor and actuator face each other directly.

The "GS-11PC" model code indicates the following specific features: