_verified_: Iosxrv-k9-demo-5.2.2.ova

Minimum of 2 (1 for Management, 1 or more for GigabitEthernet data plane interfaces) 3. Step-by-Step Deployment in VMware Workstation / ESXi

The 5.2.2 demo image remains popular because it demands significantly fewer hardware resources than its 64-bit successors. System Requirements and Hypervisor Compatibility

When booting the virtual machine for the first time, the system automatically initializes the microkernel architecture. Hard-Coded Demo Credentials Cisco XRv - - EVE-NG

Once at the EXEC prompt ( RP/0/RSP0/CPU0:router# ), configure the dedicated management interface to enable SSH access. iosxrv-k9-demo-5.2.2.ova

To run version 5.2.2 efficiently, your virtualization environment should meet these minimum specifications: 1 core (supports up to 8 for demo purposes).

: Specifies that this is a free, evaluation version of the software. It comes with built-in throughput limitations (typically capped at 2 Mbps to 15 Mbps) to prevent use in production environments.

The VM has been assigned less than 3 GB of RAM, or your CPU virtualization extensions (Intel VT-x or AMD-V) are disabled in the hardware BIOS. Minimum of 2 (1 for Management, 1 or

: It is frequently integrated into network emulation environments like to build complex service provider topologies. Hardware Efficiency

RP/0/CPU0/router# configure RP/0/CPU0/router(config)# interface ManagementEth0/0/CPU0/0 RP/0/CPU0/router(config-if)# ipv4 address 192.168.1.50 255.255.255.0 RP/0/CPU0/router(config-if)# no shutdown RP/0/CPU0/router(config-if)# exit RP/0/CPU0/router(config)# show configuration RP/0/CPU0/router(config)# commit Use code with caution. 5. Integrating with GNS3 and EVE-NG Lab Environments

Delete the original .vmdk file and fix the permissions within EVE-NG: Hard-Coded Demo Credentials Cisco XRv - - EVE-NG

Typically a sparse virtual disk (~500MB to 1GB initially).

IOS XR utilizes a two-stage configuration model. Changes made in the CLI are placed into a target configuration buffer and do not take effect immediately. You must explicitly execute the commit command to apply your configurations.