40278 Water — Softener Full Repack

Open the brine tank. Is the water level significantly higher than usual? If the tank is nearly to the top with water, you’ll need to manually remove some water (using a bucket or shop vac) to get below the float level before the system can reset. Step 2: Clean the Nozzle and Venturi

Before we panic, let’s establish a baseline. A brine tank is never 100% dry. During the regeneration cycle, the system fills the tank with water to dissolve salt, creating brine. It then sucks that brine out to clean the resin beads.

Can reduce up to 10 ppm of ferrous iron and soften water up to 90 grains per gallon .

While the model number (often associated with Morton or North Star systems) is a reliable workhorse, like any mechanical device, it can run into issues. If your brine tank is "full" of water and won't go down, here is a deep dive into why it’s happening and how you can fix it yourself.

Seals and gaskets typically last 8-10 years before resin breakdown occurs. ⭐⭐⭐⭐⭐

Turn off the water supply, remove the injector, and clean it thoroughly with warm water. You can soak it in a descaler like CLR to remove deposits. 3. Blocked Drain Line

If your water suddenly feels hard again and the display says "FULL," here is how to fix it.

: The "Demand Regeneration" computer tracks water usage and only cycles when necessary, saving both water and salt compared to timer-based units .